Decoder installation on T9.3/BR 91 for N (1:160)

Locomotive:        Flieschmann на T9.3/BR 91 в N ( 703002)
Decoder:             Flieschmann without sound NEM651 (6 pins)- FLM-685502-158436/ 35 mm cable length
Digital format:     DCC 
Interface:            No
Milling:                No

An engine that you made ​​a mistake with this bug in its coloration and the amount in1:160 scale, but simple and amenable to digitization. Model 91 is the same. Thislocomotive has a new engine (5 pole), but I think with the old engines available on the same decoder will do it ... and no other 

1. We download hollow .. you see the black ceiling of the cab .. It is a burden that will remove the decoder to collect .. otherwise no other chance .. other burden rests directly on the frame, but do not want to mill.

2. Interrupt bus to the lamp and drop adhesive fixation, there is only one point of contact to the light.

 

3. It is a "thin" diagonal break Bus poles of the motor. The difficulty is that there are two buses on each other. And plays a scalpel. If you have trouble, you can just close the plate which rests on the brush and to weld the wires onto the brush, but it's sucha personal performance do not like. Slight curves common bus, because the gap is less than a millimeter.

 

4. Desoldering coil and capacitor.

 

5. On the decoder unsolder plug

6. With foam tape (from decoder set) sticking on the engine, slightly withdrawnforward position of the decoder. Solder and wire.


7. Solder wires (yellow was cut, because the model has no tail lights)

8. Test the tracks before I close ... And after closure revealed an eyesore in the window ...

9. Put into The game  a black permanent marker, which embellish the part of conductors that can be seen and after repeated closing and setting things look better

10. And let a buzzing bee and wish to cure time ..

Натиснете тук за голяма снимка.