Decoder installation on BR 56 for N (1:160)

Locomotive:        Flieschmann на BR56 в N (7157)
Decoder:             Flieschmann without sound NEM651 (6 pins)- FLM-685402-158435/ 80 mm cable lenght
Digital format:     DCC 
Interface:           No
Milling:                Small and easy

A seemingly difficult to digitize locomotive, but it was pretty easy andvulnerable-enough space for the decoder and cables. This helps both highplacements boiler and the fact that the cabin doesn't sits snugly on the frame and there are gaps for passage of cables.

So here it is beauty:

1. Remove the hollows

2. For starters drop one drop of glue on the plate of the lamp, which will cut later, butwhile doing other things, it will dry

3. Now a look back to the locomotive decoder. Unsolder the decoder plug.

4.Desolder coil and capacitor

5. The remaining plates sticking them shorter, such as the back made ​​it sink to the bottom, since there may not be necessary

6. Heading to the embedding decoder. Use the hollow under the cab. Unfortunately,not enough to half a millimeter is placed vertically in the furnace, but flat and not bad.A slightly oblique to the axis of the screw fastening hollow. I use a thin scalpel.

7.Set the decoder and only half stick tape, which fixate the wires and the engine in the tender.
Solder the leads of the lamp (white) and power (red and black). See and interruptionof the bus to the lamp ...

8. Close the locomotive and go to the tender. Solder wires and close the tender as well.

9. We say cheers to purr like a kitten handsome